If you use a tile mat as we did (we used Bondera), begin by laying out your tile pattern on top of the mat before removing the top liner.
Mark the lines on your tile which will need to be cut to fit within your layout. Mount the SM540 wheel onto your Dremel Saw-Max tool. With your tile clamped onto your work area, make a smooth pass along the marked line, following the notch at the front of your tool to ensure an accurate cut.
Next, prep your wall, making sure it is clean and dry.
Typically, tile mats can be applied to any flat, smooth, stable surface.
Finally, place your tiles on the mat, applying firm pressure for 5 seconds.
©2016 Robert Bosch Tool Corporation. All Rights Reserved.