• Scrap Wood
• 26 gauge galvanized sheet metal
• Brads or Nails
First, cut the stakes to desired length and shape with your Saw-Max™. Then, using your Dremel Multi-Max™, sand the edges to get a clean smooth appearance.
Next, finish your stakes as desired. We stained ours and applied a coat of varnish to seal and protect them.
Next, using the Dremel 200 cut sheet metal plaques with EZ409 EZ Lock™ 1-1/2" Thin Cut, Cut-off Wheels. Grind sharp edges smooth with the 932 Aluminum Oxide Grinding Stone and drill holes at each corner using the 631-01 Brad Point Drill Bit Set.
Finally, attach the plaques to your stakes using brads or small finish nails and etch your desired names with Dremel 200 and 113 Engraving Cutter.
©2016 Robert Bosch Tool Corporation. All Rights Reserved.