• Paper for templates
• Spray Glue
• Lego Baseplate
• Lego Bricks
• Key Rings
• Drill & Drywall Screws
What you'll need:
Have you ever been late getting out the door because you couldn't find your keys? Now you can always keep them in their own home-base by creating a lego block key rack and keychain that snaps onto its designated rack!
Begin by spray-mounting your desired anchor template onto your thin baseplate sheet. Print off one of your own, or freehand it!
Next, with a MS51 blade secured in your Moto-Saw tool, set the Moto-Saw to high-speed and trace along the outside of your template.
The Moto-Saw leaves a smooth, clean finish. However, if you notice any shaping or cleaning up that needs to be done, we recommend using your NEW Dremel 4200 tool equipped with a fine sanding accessory like the EZ413SA.
The EZLock discs work well to get into tight areas like we had on our house shape!
Next, drill a pilot hole on your anchor shapes. These holes will be used to secure drywall screws though the anchors, into your walls.
We wanted to cover up our screws with lego pieces, so you may want to consider placement of your pilot holes based on where you'd like to add additional lego pieces.
To make the pilot holes, set a piece of scrap material underneath your anchor shape to protect your worktable. Then, mount your 150 Drill Bit into your 4200 tool, set the tool to full speed and plunge straight down into your pilot hole mark.
Using the same drilling technique as you used in step 3, drill a hole through the top, center of a lego brick. Thread your key ring through the drilled hole.
Finally, sink drywall screws into your pilot holes to secure your anchor plates into place.
Fit your lego keyring onto its designated baseplate!
©2016 Robert Bosch Tool Corporation. All Rights Reserved.